How does the ILCO remote access controller work?
The Ilco Remote Access Controller operates special access points such as elevators, parking entrances or any other door requiring an electric strike or electro-magnetic lock. The Ilco RAC is can operate using the dormakaba Mobile Access Solutions, allowing guests to use their mobile devices as their room key.
How does the ILCO RAC work?
The Ilco RAC is can operate using the dormakaba Mobile Access Solutions, allowing guests to use their mobile devices as their room key. If playback doesn't begin shortly, try restarting your device. Videos you watch may be added to the TV's watch history and influence TV recommendations.
What does RAC stand for?
With RAC (Remote Administrator Control) you can work without any limits. on a remote computer with operation system Windows®, Main Advantages: RAC Client is free, safe, has real speed, enables controlling computers from any network around the world even without public or static IP address more.
How to deactivate RAC 4XT?
In order to deactivate the RAC 4XT system, disconnect both terminals from the battery back-up (if equipped), then disconnect the AC power either by removing the power adaptor from the wall outlet, or by shutting off the main power to the electrical outlet the system is connected to.
What peripherals can be used with RAC 4XT?
The RAC 4XT can also be used with the following types of peripherals: • Exit Devices • Motion Detectors • Panic Bars • Request to Exit (REX) button • Remote Unlock Button • Remote Programming Interface.
What version of software is used for RAC 4XT?
Programming of the RAC 4XT can only be done with the following versions of programming device software: - ATLAS: software version 1.0 or higher - Kaba Ilco 780 FDU: software version 6.40 or higher - Kaba Ilco FDU 4 (G4): all versions (R) Front Desk Unit (FDU) (R) ATLAS with Infra-red Programming Module (IPM)
What is RAC 4XT?
The RAC 4XT is designed to operate electrical locking or control devices where a stand-alone electronic lock is not practical. It provides ingress & egress access control that can be programmed with the full range of Solitaire 710 / 710-II, Generation 760 / 770 / 790, or System
How to wire a tamper switch to a premise alarm?
To wire the tamper switch to the premise alarm system disconnect the wires on controller PCB connector J7 pins 1 & 2, and run a 2-connector cable from the switch to the premise alarm system.
Can you install RAC 4 in elevator?
If installing the RAC 4 in an elevator cage environment, or in proximity to any other equipment that may generate high levels of electromagnetic interference, follow the installation requirements as indicated in Annex C to prevent any operational instability.
Does Kaba Ilco cover damage?
Kaba Ilco’s standard warranty does not cover damages caused by installation. The RAC 4XT should always be installed in a secured room or facility with controlled access to prevent access to the system.
