How to access your USB-elicenser key remotely?
Donglify gives you an efficient way to access your USB-eLicenser key remotely and run Cubase, Nuendo, or WaveLab apps on a computer that has no USB-eLicenser physically attached. Read on to learn more. 2.1. Step-by-step guide Connect to an eLicenser dongle over the Internet. Alternative solution
What is Vava remote access information?
VA Remote Access Information. A resource for employees to connect remotely using Cisco AnyConnect VPN (also referred to as RESCUE) or the Citrix Access Gateway (CAG). If you are experiencing problems connecting, please contact the Enterprise Service Desk at 855-673-4357 (TTY: 1-844-224-6186).
Can I Share my elicenser key with other computers?
As it often happens with software protection dongles, your eLicenser key may be lost or damaged as a result of being constantly moved between different machines. To avoid the device’s wear and tear and prevent the loss of your valuable hardware key, you may try to share it with other of your computers over the network.
How do I request remote access to the self-service portal?
You may request remote access by visiting the Remote Access Self Service Portal ( only available while on VA's internal network). Please note the Self-Service Portal is only accessible from within the VA network, it is not externally accessible.
How do I use USB-eLicenser?
1:164:29Cubase 10 101: The Beginner's Guide to Cubase - 3. The USB-eLicenserYouTubeStart of suggested clipEnd of suggested clipYou can use the go in the finder. To go to your applications to find the elicenser control centerMoreYou can use the go in the finder. To go to your applications to find the elicenser control center software. And that is in the e section right here Eli sansar Control Center will load that typically.
Do I need a USB-eLicenser?
Do I need a USB eLicenser key? Most software using the eLicenser activation system will require the use of a USB eLicenser key. However, some products (such as Steinberg's Cubase LE) do not require a USB eLicenser and are instead activated directly to your computer's hard drive. This is known as a Soft eLicenser.
What is eLicenser control center?
The eLicenser Control Center is a utility that allows for managing music software licenses by a variety of manufacturers. Via the eLicenser Control Center licenses can be downloaded and stored on a USB-eLicenser (dongle, license key) or in a Soft-eLicenser (virtual license container on hard disk).
How does Steinberg eLicenser work?
The USB-eLicenser is a small USB key (dongle, formerly Steinberg Key) on which music software licenses by different manufacturers can be stored. For licenses on a USB-eLicenser are independent of a specific computer, the corresponding software can be used on any computer to which the USB-eLicenser is connected.
Can I use Cubase 11 without eLicenser?
With this, you can only run Cubase on the computer that has the Soft-eLicenser installed or a machine with the USB-eLicenser connected to it. What's more, customers have had to buy a USB-eLicenser before trying out the Cubase Pro demo.
How do you use eLicenser?
If the required USB-eLicenser or Soft-eLicenser is displayed, click on the green button [Enter Activation Code] at the upper left of the eLicenser Control Center. Enter Activation Code. Of course, you can also copy and paste the code into the input field. The Activation Code must not have been used before.
How do I get eLicenser?
0:594:22Activating Steinberg Products with an Activation Code | Support - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe Cubase AI is installed on my system. Part of the installation. Process is the installation of anMoreThe Cubase AI is installed on my system. Part of the installation. Process is the installation of an application called the elicenser control center.
What is Steinberg eLicenser?
The USB-eLicenser is a copy protection device which is required by many Steinberg products. With the full versions of the Cubase, Nuendo and WaveLab host applications, the USB-eLicenser is usually included in the product package.
How do I make a soft-eLicenser on my computer?
Select “Registration” from the top menu, choose the 20-digit Soft-eLicenser number and click on “Copy Serial Number”. If you registered the previous license it will auto fill your previous registered activation code in the old activation code field.
Does Cubase still need a dongle?
Yes, of course you still need the dongle, or soft eLicenser for those. Only Cubase and Dorico use the new licensing system so far.
How many computers can I use Cubase 12 on?
Use on multiple machines You are allowed to install our products on multiple computers, but you can only activate a product on three computers at any one time.
Can I use iLok with Cubase?
You still need the elicenser software installed, much like the iLok one, and it authorises Cubase on your system using a Hardware stamp. Remove the need for the actual dongle and leave it as it is. That's the only way I use iLok, as a software licenser, I have no issue with that.
How do I transfer Cubase from one computer to another?
Should you need to change computers/re-install your operating system, you will need to re-activate Cubase following these steps.Log into your Steinberg.net account.Click 'Reactivate'.Select your old Soft eLicense from the list.Now, enter your new Soft eLicense number.More items...•
How do I register my eLicenser on Steinberg?
Log in to your MySteinberg account....Click on the button [Register eLicenser / software].A new page opens, prompting you to enter the number of the eLicenser holding your license - or the Activation Code you've used to download the license.Registering via eLicenser number. ... Registering via used (!) Activation Codes.More items...
How do I set up a Steinberg account?
0:003:51How to Register Steinberg Software | Support - YouTubeYouTubeStart of suggested clipEnd of suggested clipSection of the Steinberg. Website and enter or create a Steinberg ID. Now you do this by enteringMoreSection of the Steinberg. Website and enter or create a Steinberg ID. Now you do this by entering your email address enter a password and repeat the password. You can specify region.
How do I license my Cubase 12?
0:217:24Cubase 12 licensing without dongle: Released!! - YouTubeYouTubeStart of suggested clipEnd of suggested clipWith a download access code and you can use that in the download assistant from steinberg.MoreWith a download access code and you can use that in the download assistant from steinberg.
What is a Steinberg eLicenser key (dongle)?
A Steinberg USB eLicenser key (also referred to as a “Steinberg dongle”) is a compact flash-drive-looking device that is used to hold the license...
Soft-eLicenser vs USB-eLicenser
Unlike the Soft-eLicenser, the hardware USB-eLicenser allows you to run your software copy across multiple computers. The eLicenser dongle has to b...
How can I transfer my license from one eLicenser USB dongle to another?
First of all, you need to make sure that you have the latest version of eLicenser Control Center software installed on your computer and that the...
What is the eLicenser Control Center software?
The eLicenser Control Center is a utility that makes it possible to manage the licenses of a wide variety of music software. By using the eLice...
Do all Steinberg products require an eLicenser USB dongle?
No. Some solutions do not require a hardware USB key and are activated using the Soft- eLicenser that stores your license info directly on your com...
How to request remote access VA?
You may request remote access by visiting the Remote Access Self Service Portal ( only available while on VA's internal network).
How to disable automatic server selection in VPN?
In the VPN tab of the setting screen, uncheck Enable automatic server selection. Close the settings.
What is a rescue GFE?
RESCUE GFE provides a security posture check and ensures VA data is encrypted from the end device into the VA trusted network. Prior to the device connecting and being allowed onto the VA trusted network the system is checked for multiple security baselines.
How to enable TLS 1.1?
To enable TLS within Internet Explorer: Select ‘Tools’, then ‘Internet Options’, then the ‘Advanced’ tab. Enable the checkbox for ‘Use TL S 1.1’ (found towards the end of the list).
Is PIV card reader site specific?
Today, the distribution of PIV card readers is site-specific. We are discussing the possibility of alternative distribution methods. If distribution processes or procedures change, we will provide updated instructions.
Is VA responsible for non-VA websites?
This page includes links to other websites outside our control and jurisdiction. VA is not responsible for the privacy practices or the content of non-VA Web sites. We encourage you to review the privacy policy or terms and conditions of those sites to fully understand what information is collected and how it is used.
Does RESCUE GFE support Windows 10?
This software is installed on all GFE laptops prior to being provided to the user. Currently RESCUE GFE supports Windows 7, Windows 8, Windows 10 and MAC OSX.
2.Soft-eLicenser local license generator b20.exe
This report is generated from a file or URL submitted to this webservice on July 30th 2020 22:06:42 (UTC) Guest System: Windows 7 32 bit, Professional, 6.1 (build 7601), Service Pack 1 Report generated by Falcon Sandbox v8.31 © Hybrid Analysis
Indicators
Not all malicious and suspicious indicators are displayed. Get your own cloud service or the full version to view all details.
