"Remote Access Connection Manager failed to start because it could not load one or more communication DLLs. Ensure that your communication hardware is installed and then restart the Remote Access Connection Manager service. If the problem persists, contact the system administrator.
Full Answer
What should I do if my hp smartcard reader fails?
If the Smartcard is valid then the HP Smartcard reader might have failed. Contact the system administrator to ensure that the card is valid and configured correctly. If the card is valid and configured correctly, then contact HP Support to replace the HP Smartcard NIPRNet Solution.
Did hp leave a reconnection cookie on my computer?
If it was a legitimate HP support session you have nothing to worry about but there are unfortunately some bad actors out there posing as HP reps and if you connected to one of those they probably did leave a reconnection cookie on your computer. Those guys do generally try to get money from you while you are talking to them however.
Why is the hostname on my HP printer not correct?
The server hostname is incorrect or is not a valid hostname. To determine if the host name is valid, open a command shell and type: ping <LDAP hostname>. If ping cannot find the host, then it is probably not the correct host name. The DNS settings on the HP printer are incorrect.
What happens if you enter incorrect pin?
After entering an incorrect PIN successively three or more times, the Smartcard is disabled as a security measure. Once a Smartcard is disabled, it must be replaced.
Why is my signature invalid?
The signature is invalid because you have either distrusted or not yet chosen to trust the following Certificate Authority: Issued By: <CA Issuer Name>.
How to check if host name is valid?
To determine if the host name is valid, open a Windows command shell and type: ping <kerberoshostname>.
How to get the skip disk to load?
Press and release the Start key. The printer should now display “SKIP DISK LOAD”.
Why is my email not appending the intermediate and root certificate?
The device is not appending the intermediate and root certificates in the e-mail message because they have not been installed on the device.
Can you reinstall a smart card?
The entire Smartcard installation and configuration must be completed again. This includes reinstalling the Smartcard authentication update and performing all of the necessary EWS configuration steps.
How to restart a Windows connection?
Right-click on Windows Connection Manager, then select Restart.
Is HP liable for technical errors?
HP Inc. shall not be liable for technical or editorial errors or omissions contained herein.The information provided is provided "as is" without warranty of any kind.To the extent permitted by law, neither HP or its affiliates, subcontractors or suppliers will be liable for incidental, special or consequential damages including downtime cost; lost profits; damages relating to the procurement of substitute products or services; or damages for loss of data, or software restoration.The information in this document is subject to change without notice.HP Inc. and the names of HP products referenced herein are trademarks of HP Inc. in the United States and other countries.Other product and company names mentioned herein may be trademarks of their respective owners.
Monday, 29 August 2011
Remote access functionality, sometimes called "Lights Out" management, is a standard feature on mid- and high-end servers. It allows a system administrator to remotely access the console of the server as well as performing power on, off and reset operations.
HP Microserver: Remote Access Card
Remote access functionality, sometimes called "Lights Out" management, is a standard feature on mid- and high-end servers. It allows a system administrator to remotely access the console of the server as well as performing power on, off and reset operations.
