What is the kantech kt-400?
The Kantech KT-400 is an Ethernet-ready four-door controller that provides 128-bit AES encrypted communication with the EntraPass system and is a highly secure solution for any security-conscious business.
How does the kt-400 work with entrapass?
The KT-400 can easily be integrated into an existing EntraPass system with other Kantech controllers (KT-100 and KT-300) or can provide the foundation for a brand new security installation. With an onboard Ethernet port, an external IP device is no longer required to connect to the network.
What is the onboard port on kt-400 used for?
The onboard port is dual-sensing, which means the system senses whether the connection is 10Base-T or 100Base-T and adjusts automatically for faster connectivity. KT-400 manages network polling and communicates with the EntraPass Gateway only when an event has occurred.
How do I connect to KT 400?
Connecting an OSDP HID readerDisconnect the power to the KT-400 controller.Connect the reader's red wire to the +12VDC.Connect the reader's black wire to the earth ground GND.Connect the reader's RS-485-A wire/terminal to the COM2 485 +.Connect the reader's RS-485-B wire/terminal to the COM2 485 -.
How do I use KT Finder?
KT-Finder is a stand alone application you can carry with you. Launch application. (IP Link and KT-Finder must be in the same IP range)Select IP Link next to Device. Enter MAC Address and click Connect.
How many kantech controllers can you put on a communication loop?
Up to 32 controllers in daisy chain configuration.
How do I add a new controller to kantech?
Click the New ( ) icon in the site definition window. Rename the Site (use the name of the building or floor where the controllers are installed). Select the number of controllers. Click the Options tab and select the Connection type used to connect the site to EntraPass.
How do I factory reset my KT 1?
Locate the Reset button in the lower right of the main board. See Figure 1. Press Reset for less than 2 seconds. Press Reset for 3 seconds until you hear 5 beeps.
How do I factory reset my kt400?
ProcedureRemove jumpers JP2 and JP3. For more information about factory default DHCP mode, see Troubleshooting.Press the Reset button.Check the blue heartbeat LED pattern.Verify the IP address using the KT-Finder. ... Configure the KT-400 using the KT-Finder.