Fix UniFi Devices Disconnecting by Force Overriding Inform Host After signing in, navigate to Settings > Controller. Under Controller Settings, enter the IP address of your controller and make sure the Override inform host with controller hostname/IP box is checked.
Full Answer
How to fix unifi devices disconnecting in Windows 10?
2. Fix UniFi Devices Disconnecting by Force Overriding Inform Host After signing in, navigate to Settings > Controller. Under Controller Settings, enter the IP address of your controller and make sure the Override inform host with controller hostname/IP box is checked.
How do I find the IP address of my unifi controller?
If you’re not sure, you can run nslookup unifi in a terminal to determine your controller’s IP. In this case, the IP address of my UniFi controller is 10.0.0.5. 2. Fix UniFi Devices Disconnecting by Force Overriding Inform Host
How to fix unifi disconnected access points?
Accessing the access points through SSH and running set-inform http://unifi:8080/inform fixed the problem, but only for a short while. After a few hours, the access points would revert to being in their disconnected state.
Why is Ubiquiti disconnecting from my account?
Verify your account to enable IT peers to see that you are a professional. I have had links go down in remote buildings that feed the backbone connection to the Ubiquiti server controller software. That causes a disconnect to show.
What is the firmware version of the USW switch?
We noticed all our USW switches had been sitting on firmware version 5 of the Unifi firmware release, so we reviewed the release channel and found: UAP-USW-Firmware-5-43-36
How long do you stay on site after installing a new computer?
Once the equipment was installed, updated, provisioned, and programming, we started our testing. As with all of our projects, we stay on-site a minimum of 48 hours after installation and programming. This procedure gives us confirmation that all units are running smoothly with no issues.
Is there a new issue during installation and upgrade at a facility in North America?
We have found a new issue during the installation and upgrade at a facility in North America. We have experienced a new “disconnected” challenge. We will walk you through the findings and the fix that we applied, and hopefully, some of you will save some hours that we had lost.
Can you ping all disconnected UAPs?
It was time to go to the terminal. It was possible to ping all of the disconnected UAPs, so we continued to login in via SSH. Running info command returned below information: